Today I show you how I did the dog eyes on the bike box. This is pretty much the same method that I used in the koala.
Sadly I don't have many photos of the process, but I do have the video.
The hardest part was threading the wires through the dog's head. I did this by sending a wire through each eye hole to the back of the head where I had a big hole, which was easy to grab wires. I then soldered the various wires to each threading wire, and then pulled them through before desoldering them.
Above: Imported image from the old system
Above: Imported image from the old system
Above: Imported image from the old system
Above: Imported image from the old system
Above: Imported image from the old system
Above: Imported image from the old system
Above: Imported image from the old system
Above: Imported image from the old system
Above: Imported image from the old system
Above: Imported image from the old system